Transformer for Halogen and LED illumination

The transformer VSL 20 and VSL 3W LEDs are used for the power supply of small power consumers, such as the microscope illuminator. The unit can be heated (VSL 20) during operation (especially at work with full capacity). This is functional. Take care and ensure that the cooling slots on the transformer are not covered. A firm stand is recommended. The transformer can be switched on with the green switch located on the front side. This switch is illuminated for control. The output voltage and thus the brightness of the illuminator is controlled by the control dial on the front side of the transformer. The power supply connection and the connection for the illuminator are located at the rear. The transformer are only suitable for use in a dry environment!

Transformer for Halogen (left in the picture) and LED (right in the picture) Beleuchtung   Technical data VSL 20 (for 10W Halogen)

  • Transformer 10W, adjustable (058544:500.26)

Input voltage:   230V;50Hz
Output voltage:   1,2-6V AC continuous
Output power:   max. 10VA
Safety class system:   2
Degree of protection:   IP 20
Environmental temperature:   35 °C
Fuse:   230V 160mAT
  Technical data VSL 3W LED

  • Transformer 3W-LED, adjustable  (058544:510.26)

Input voltage:   115V-265V; 50 - 60 Hz
Output voltage:   1,2-6V AC continuous
Output power:   max. Sek. 700mA
Safety class system:   2
Degree of protection:   IP 20
Environmental temperature:   35 °C